Flexible Multimodal Sub-Gigahertz Communication for Heterogeneous Internet of Things Applications

To realize low-power and low-cost wireless communication over long distances, several wireless standards using sub-1 GHz frequencies have recently been proposed, each with their own strengths and weaknesses in terms of coverage, energy consumption, and throughput. However, none of them are currently flexible enough to satisfy the requirements of future dynamic and heterogeneous IoT applications. To alleviate this, a novel architecture that uses a multimodal device for flexibly employing a variety of heterogeneous sub-1 GHz wireless networks is proposed. It greatly increases network flexibility, resilience, and performance. A device design is presented together with an abstraction layer that combines the different networks into a single flexible virtual network substrate. The article elaborates on the qualitative advantages of this approach. Measurement-based simulation results show advantages in terms of energy efficiency, with significant reduction in energy use compared to a single-technology solution in a representative IoT track and trace scenario. Finally, the article identifies several open research challenges that need to be resolved to fully realize this vision of flexible multimodal communication for demanding IoT applications

Accurate Energy Consumption Modeling of IEEE 802.15.4e TSCH Using Dual-Band OpenMote Hardware

The Time-Slotted Channel Hopping (TSCH) mode of the IEEE 802.15.4e amendment aims to improve reliability and energy efficiency in industrial and other challenging Internet-of-Things (IoT) environments. This paper presents an accurate and up-to-date energy consumption model for devices using this IEEE 802.15.4e TSCH mode. The model identifies all network-related CPU and radio state changes, thus providing a precise representation of the device behavior and an accurate prediction of its energy consumption. Moreover, energy measurements were performed with a dual-band OpenMote device, running the OpenWSN firmware. This allows the model to be used for devices using 2.4 GHz, as well as 868 MHz. Using these measurements, several network simulations were conducted to observe the TSCH energy consumption effects in end-to-end communication for both frequency bands. Experimental verification of the model shows that it accurately models the consumption for all possible packet sizes and that the calculated consumption on average differs less than 3% from the measured consumption. This deviation includes measurement inaccuracies and the variations of the guard time. As such, the proposed model is very suitable for accurate energy consumption modeling of TSCH networks